Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - GoingRGB

Pages: [1]
1
Do You Need Help? Post it here / Re: SOLVED! Mega Tree only 1/3 lit
« on: December 14, 2017, 12:02:45 AM »
Thanks for the replies. 


It seems the issue was 2-fold: interference (solved by adjusting universe setup for controller 2) and a corrupted Xschedule (solved by reinstallation).

2
Do You Need Help? Post it here / Re: Mega Tree only 1/3 lit
« on: December 13, 2017, 05:05:25 PM »
It could be that the end channels have no recalculated yet so it's just a display issue.  But you have several weird things in those screenshots.  The controller config has universe 1 for every output.  The tree will not conflict with that model after it because you have them on completely different IP addresses.

Thank you.  There's definitely a recalculation issue, but I don't know how to correct that as it auto-populates.  I've started from scratch (reset controller & new install of Xlights) and the issue persists.

3
Do You Need Help? Post it here / SOLVED! Mega Tree only 1/3 lit
« on: December 13, 2017, 11:34:32 AM »
No idea what's wrong.  I tried the Facebook groups first, and I'm still in the same place.

We have reset the controller to defaults, reinstalled Xlights (now v.41), used plain bars to test.... Nothing.  Nothing works on the tree past pixel 17!!  It's just blackness.

Any help is appreciated.

Photos:
IMG_7446 - the bad tree
Setup 1 - Controller setup
Issue with channels? - With the above Xlights controller setup, why is this automatically ending 100 channels into the next model?
Setup 6 - putting in 150 channels in setup and no more issue on channel Garage Peak L (50:2)

Pages: [1]