1
Xlights Setup / Re: Spinner wont spin :)
« on: November 21, 2020, 08:39:44 AM »
Thank you Keith~
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Xlights Setup / Re: Spinner wont spin :)
« on: November 20, 2020, 01:35:12 PM »
zoom meeting? or zoom on model? If zoom on model, it works just fine on model and preview in xlights, it only lights 4 lights on the physical model.
3
Xlights Setup / Spinner wont spin :)
« on: November 19, 2020, 06:31:22 PM »
Very new....
I have setup a model spinner as follows:
1 string
arms 16
lights on arm 11
hollow 5%
start angle )
Arc 360.
When I test on the controller all the lights light up. When I test in the Xlights program only the first 4 lights work. Tested it on other strands same issue.
Where should I start on diagnosis?
Again a total newbie and jumping in.
I have setup a model spinner as follows:
1 string
arms 16
lights on arm 11
hollow 5%
start angle )
Arc 360.
When I test on the controller all the lights light up. When I test in the Xlights program only the first 4 lights work. Tested it on other strands same issue.
Where should I start on diagnosis?
Again a total newbie and jumping in.
4
General hardware / Can I use the Lightorama Hardware with Xlights?
« on: March 27, 2019, 09:50:39 AM »
Hello, new user, after using lightorama and purchasing a 16 ribbon CCR tree, I find that I am wanting to switch over to Xlights. Can I still use the hardware and the CCR ribbons with X-Lights? I want to run the Xlights with the lightorama stuff and build my own stuff. I apologize if I missed a thread that talks about this. I just want to know if I need to sell my LOR stuff or if I can incorporate it into the xlight builds.
Thank you for any help.
Thank you for any help.
Pages: [1]