1
Nutcracker Autogenerate Sequence / Autogenerate Mouth Movements
« on: December 01, 2017, 07:52:02 AM »
Is there a way to autogenerate mouth movements for a snowman or a pumpkin?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
The Water Cooler / Complete NOOB question
« on: December 01, 2017, 07:26:13 AM »
Hello all, first post to the forum.
I Have a Pixlite 16 board, picked up the pig tails, power supply and cables, also got a ton of ip68 ws2811 pixels, then built a megatree, tested everything (and it works amazingly enough). I also built a raspberry pi lighting controller using a 16 channel relay and lightshow pi (which is freaking awesome). I put a playlist together on my lightshow pi controller which runs basically my entire house, yard, and other lighting pieces. I then hooked up a low powered FM transmitter (so im not driving my neighbors nuts by having an amp running music every night).
So here is the question:
Is there a way to channelize frequencies then map them to effects which will play on a real time stream?
Is this a possibility?
How would you approach making both independent controllers work together without spending countless hours creating sequences and trying to keep them in sync?
Sorry if this question has been covered, I didnt see anything that referenced this however I could have easily missed it.
Cheers..
I Have a Pixlite 16 board, picked up the pig tails, power supply and cables, also got a ton of ip68 ws2811 pixels, then built a megatree, tested everything (and it works amazingly enough). I also built a raspberry pi lighting controller using a 16 channel relay and lightshow pi (which is freaking awesome). I put a playlist together on my lightshow pi controller which runs basically my entire house, yard, and other lighting pieces. I then hooked up a low powered FM transmitter (so im not driving my neighbors nuts by having an amp running music every night).
So here is the question:
Is there a way to channelize frequencies then map them to effects which will play on a real time stream?
Is this a possibility?
How would you approach making both independent controllers work together without spending countless hours creating sequences and trying to keep them in sync?
Sorry if this question has been covered, I didnt see anything that referenced this however I could have easily missed it.
Cheers..
Pages: [1]