1
My Show Setup / Re: Changes Layout
« on: March 21, 2018, 03:02:05 AM »
Thanks Keithsw for your rapid and efficient answer
Regards
Regards
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
My Show Setup / Changes Layout
« on: March 20, 2018, 03:04:21 PM »
Hello
I'm new on this forum, I'm living in the south of France and I discovered Pixels ,controllers and lights last year.
Last christmasy I ran my first pixel show, it worked perfectly but was a little bit a simple one.
I run a F16v3 with 2 differential expansion board controlled by a Pi, my display is composed by
a mega tree 2400 pixels, 4 arches, 6 circles (700 nodes) 11 stars 10minitrees with mini stars 5 candy canes Singles lines on the roof, 12 singles lines
My question today (hope my english is good enough to explain clearly my pb) I began several weeks ago a musical show (French version of let it go from frozen) and it is almost finished. but today to fulfill what I want to do I cut a single line of 150 nodes into 3 of 50 nodes. They appear in the layout of Xlights but when I load the sequence I did save before these 3 lines don't appear, the only first one is on the list of display
Is there a simple method to get my changes of display so I can go on and finish my sequence without doing it again since the beginning totally.
This software is fantastic
Best regards from France
I'm new on this forum, I'm living in the south of France and I discovered Pixels ,controllers and lights last year.
Last christmasy I ran my first pixel show, it worked perfectly but was a little bit a simple one.
I run a F16v3 with 2 differential expansion board controlled by a Pi, my display is composed by
a mega tree 2400 pixels, 4 arches, 6 circles (700 nodes) 11 stars 10minitrees with mini stars 5 candy canes Singles lines on the roof, 12 singles lines
My question today (hope my english is good enough to explain clearly my pb) I began several weeks ago a musical show (French version of let it go from frozen) and it is almost finished. but today to fulfill what I want to do I cut a single line of 150 nodes into 3 of 50 nodes. They appear in the layout of Xlights but when I load the sequence I did save before these 3 lines don't appear, the only first one is on the list of display
Is there a simple method to get my changes of display so I can go on and finish my sequence without doing it again since the beginning totally.
This software is fantastic
Best regards from France
Pages: [1]