Messages

1

Do You Need Help? Post it here / Re: Reversing a single strand effect

« on: August 20, 2018, 05:34:12 PM »

Thanks!  I was able to find the video you referenced here https://www.youtube.com/watch?v=Hmz1JMcTwhE and it answered all my questions and then some.

2

Do You Need Help? Post it here / Reversing a single strand effect

« on: August 16, 2018, 10:36:39 PM »

Hello - is there a way to have the single strand effect reverse at a certain time/beat?  Right now I have a string where I reverse to certain beats back and forth.  I just have one string effect at each beat in a different direction than the previous one.  It works, but the problem is that it jumps around instead of making a smooth reverse like I want.  Thanks as always for all the help here!

3

Do You Need Help? Post it here / Re: Odd behavior after ramp effect

« on: August 15, 2018, 07:09:59 PM »

Thanks JonB256.  I realized I was not in AC mode.  The ramp works in AC mode to ramp up and stay on, but if I do it in the regular mode with a ramp 0-100 and then a 100% block immediately afterwards it will flash between the two.  Not sure why, but going into AC mode and using that toolbar fixed the issue.  I keep finding neat new things with this software every time I use it.  Great stuff!

4

Do You Need Help? Post it here / Odd behavior after ramp effect

« on: August 14, 2018, 09:27:11 PM »

Hello - I am running into an odd behavior when I ramp my AC lights.  I am ramping 0 to 100% on a channel and then have a 100% on immediately following it so that it stays on.  On my existing sequences it works fine, but for some reason tonight when I create new sequences with a ramp it flashes off and on between the end of the ramp and the start of the 100% on. I can not figure out what is going on.   Any idea why this might be happening when it is working on existing sequences?  Is there a setting I may have inadvertently set?

Using Xlights version 2018.27