Messages

1

LOR / Re: Starting with LOR ac box - doesn't work

« on: October 28, 2018, 10:22:04 AM »

You know the LOR AC controllers work with DMX?  Just have to plug them into the DMX ports of your falcon set the jumpers to LOR and plug them in.  The jumpers take care of not having to make up a LOR cable.  You did assign a universe to the DMX outputs and your sequence is set to that universe?  Is the LED on the controller on solid when hooked to the falcon if not if it's flashing it means that it hasen't synced to the falcon.  Just a few things to try.

Mark

2

Do You Need Help? Post it here / Re: xSchedule64 Question

« on: October 08, 2018, 09:03:09 PM »

That worked thanks!

3

Do You Need Help? Post it here / xSchedule64 Question

« on: October 08, 2018, 07:42:39 PM »

OK this is most likely a easy question in xschedule is there a way to have it run a startup sequence and a shutdown sequence for the show.  Example you have a sequence that runs once at the start of the show and turns on your tune to sign and at the end of the show you run a shutdown sequence to turn it off.  I tried to search but really don't know how to phrase the question 

Thanks,

Mark

4

Do You Need Help? Post it here / Re: need help

« on: September 10, 2018, 02:06:34 PM »

Ok but wouldn't it run it each time the show repeats? This would re run the sequence that would then turn off my transmitter until the show repeats again and then turn the transmitter on.  See my issue is that the transmitter in order to turn it on you have to press and hold the on button and then the same thing to shut it off.  Sorry for all the questions new to xlights.

Mark

5

Do You Need Help? Post it here / Re: need help

« on: September 10, 2018, 11:01:32 AM »

OK so do I make a playlist in xlights and then add it as a background playlist? 

6

Do You Need Help? Post it here / need help

« on: September 10, 2018, 07:22:51 AM »

ok I am converting over to xlights from LOR was able to convert my sequences ok every thing went great.  The only issue that I have is I have a script that runs when I start my show and again at the end of the show.  What is does is turns on my FM transmitter and also my tune to sign (it's an AC sign that I have a dumb RGB controller hooked to a solid state relay. (didn't want to use up a AC channel on my controller)  What I did in LOR is create a animation sequence with the 3 channels that the controller is attached and turned on each one.  (the FM transmitter has a 2 second pulse turns it on and off) what I can't figure out is how to do this in xlights.  It's most likely easy but I can't figure it out or maybe I am not thinking correctly in what I wan't to do.  Any help would be great.

Thanks,

Mark