1
Xlights Setup / Brightness / Dimming Curve
« on: December 03, 2018, 03:49:46 PM »
Trying to adjust brightness of individual models on a single port of a PiCap. Seems like the xlights dimming curve feature will do this but I seem to be having 2 problems:
1 - I make changes, re-render/save and then xfer the sequence but the change seems to not always take affect. I seem to have to mess with the brightness setting. For example to test I changed one model to -100 which resulted it in being off. I set it back to 0 and it did NOT come on, I had to go to +100 to get it back on when playing the sequence. I am probably not doing something right.
2 - Speaking of +100 - What do positive values for "brightness" do in single brightness/gamma, default is 0 (which I assumed was not dimmed). How can you get brighter than this?
(may be time to just get a controller with more ports to just handle dimming there)
1 - I make changes, re-render/save and then xfer the sequence but the change seems to not always take affect. I seem to have to mess with the brightness setting. For example to test I changed one model to -100 which resulted it in being off. I set it back to 0 and it did NOT come on, I had to go to +100 to get it back on when playing the sequence. I am probably not doing something right.
2 - Speaking of +100 - What do positive values for "brightness" do in single brightness/gamma, default is 0 (which I assumed was not dimmed). How can you get brighter than this?
(may be time to just get a controller with more ports to just handle dimming there)