Show Posts
1
Xlights Setup / Falcon player is reversing 2 strings of lights compared to Xlights
« on: November 20, 2019, 09:24:43 AM »
I am rather inept at configuring my Falcon player to play my Xlights sequences. However, for the most part I finally got everything working fairly well. But, there are 2 strings of RGB lights that seem to be reversed when I try to use my Raspberry PI (Falcon player) to set up my shows. I tried reversing the Universes in the PixLite 16 controller, but then I got no lights at all, so I had to put them back to normal. What happens, as an example, is when I do a sequence that runs a colour up my complete display, everything is working correctly except 2 strings are showing the colour going down when all the rest are showing the colour going up. These are 2 corner strings going up the side of the house.
Can anyone tell me how to fix this problem?
When I play the sequence through Xlights directly to the controller, everything works correctly. For some reason, the Falcon Player is not outputting it properly. I did clear out the controller setup in the Falcon player, and then exported the setup from Xlights to the Falcon player, but it did not solve the problem.
Thanks
SamB
Can anyone tell me how to fix this problem?
When I play the sequence through Xlights directly to the controller, everything works correctly. For some reason, the Falcon Player is not outputting it properly. I did clear out the controller setup in the Falcon player, and then exported the setup from Xlights to the Falcon player, but it did not solve the problem.
Thanks
SamB