Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LEDnewby

Pages: [1]
1
Do You Need Help? Post it here / xScheduler Shuffle question
« on: December 29, 2020, 07:20:36 AM »
Is there a way to have xScheduler shuffle a playlist, but only once?

I?m running 2020.56 and have an animation only playlist on loop from 4:45-11 each night, along with two different roughly 15 min long music playlists scheduled to fire every hour (with higher priority) that have start times 30 minutes apart so they alternate throughout the night. All the above works great, however I?d like to shuffle the music sequence playlists but still have them play only one time through, and then flip back to the animation playlist until the next music playlist fires off.

I?ve tried setting ?Shuffle? at the playlist level, but then it just keeps shuffling and never ends. Setting shuffle at the schedule level doesn?t seem to do anything as the playlist still plays in order. And I can?t choose to loop but set loop count to only once if using the ?Fire every x minutes? option.

Any way to achieve a shuffle only once?


Sent from my iPhone using Tapatalk

2
Do You Need Help? Post it here / Re: How to model arches with a shared edge
« on: December 03, 2019, 08:48:01 AM »
Thanks. I was able to get it working now. My sub models weren’t initially working as I was confused on how to properly apply nodes to Top, Bottom, etc. rows. Once I knew I was on the right track, a little more work cleaned it all up.


Sent from my iPhone using Tapatalk

3
Do You Need Help? Post it here / How to model arches with a shared edge
« on: December 02, 2019, 04:29:46 PM »
On the front of my house I have 3 posts in a line with a beam spanning across them. I’m trying to model this in xlights so that it acts like 2 arches, but with the center vertical being shared. I’ve physically strung bullet pixels up the left post across to the center post and then down. I then bring the data back up the center post and connect to pixels starting at top of center column across to right column and down.

I’ve got a Falcon F16v3 controlling things, and have been trying some different combinations of polyline models and sub models. I can get all the lights to lights up, but when doing a chase effect along one arch to the next can’t get the chase to behave as desired across the shared middle vertical.

Any tips would be appreciated.


Sent from my iPhone using Tapatalk

Pages: [1]