1
LOR / Re: No comm Lor
« on: November 15, 2020, 12:30:46 PM »
I hope this is what u asked for. this is just the pixcon 16 controller. directly connected to back of pc. thank you.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
LOR / Re: No comm Lor
« on: November 14, 2020, 05:27:29 PM »
Also I tryed to upload output.. And I get a message LOR output upload Failed. Unable to connect.
3
LOR / No comm Lor
« on: November 14, 2020, 05:05:07 PM »
Hi, after days of pulling hair out.. I Just switched to xlights from lor. Mapped everything over. Its a small show with 4 lor ac controllers and a pixcon 16. So went into xlights /controllers clicked discover, it finds the pixcon 16 little light bottom corner is green everything is great. added the lor controllers in usb dongle connection. that is green good to go. Go to control lights in xlights and nothing. either controllers work. the lor ac and the pixcon 16 still have flashing red lights. I tryed everything. I went back to lor network and can control pixcon 16. And then went into lor hardware and can control ac controllers. Can connect in xlights Any ideas? thanks in advance.
Pages: [1]