Messages

1

Paid Sequences / Re: ARTNET Setting

« on: July 29, 2021, 11:56:51 PM »

It recognized the DMX and lit up.
Thank you kindly!

2

Paid Sequences / Re: ARTNET Setting

« on: July 29, 2021, 10:27:11 PM »

This is the MADRIX settings screen when the connection is properly established.



This is my xLights configuration screen, which is not connected.



I would appreciate your continued advice.

3

Paid Sequences / Re: ARTNET Setting

« on: July 29, 2021, 10:06:27 PM »

Thank you!
I'll take a picture and post it as soon as I can.

4

Paid Sequences / Re: ARTNET Setting

« on: July 29, 2021, 08:11:00 PM »

Thanks for your reply, keithsw1111.
I think you are right about Artnet Universe.
I'm using MADRIX and it works fine.

As for the current situation
When I access the IP of the ARTNET interface, I can browse.
When I turn on the lamp with xLights, the data lamp of the interface is responding.
The lights connected by DMX cable keep giving me a no signal error.

I think there is a problem with my setup, but I can't seem to solve it...
(I'm using a translation tool)

5

Paid Sequences / ARTNET Setting

« on: July 29, 2021, 01:32:34 AM »

This is Kimoto in Japan.
I want to control DMX pixel lights from xLights using the ARTNET interface.

I am a beginner, so please tell me how to set it up.

I can connect to the ARTNET interface by entering the IP address.
Also, when I turn on the lights, the ARTNET interface responds as if it is getting a signal.

However, the DMX light does not light up.
This means that the DMX signal is not connected.

I've been trying for about a week now, but the situation hasn't changed at all.

I would like to know more about setting up xLights using the ARTNET interface.

(I'm using a translation tool)

Translated with www.DeepL.com/Translator (free version)