Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marksat

Pages: [1]
1
Ok - I put up the megatree, but the center/start point is not where I meant to put it (e.g. string 1 should be pointing due South, but is off a bit).

Is there a way to adjust the model output in XLights (instead of physically re-positioning the strands of the tree, or adjusting every sequence)?

I tried adjusting the RotateY attribute on the Layout tab, Size/Location area but that does not seem to do anything.

Thank you in advance.

Pages: [1]