Messages

1

Do You Need Help? Post it here / Re: Models not assigning to my 1 and only controller. What is happening?

« on: November 16, 2021, 01:41:50 PM »

I had made a few shows last year with the same controller and an update or two in-between that would auto assign each model directly behind the next model and to my only controller. So I know it has worked the way I am hoping it should. It just seems not correct to jump to one channel past my last channel.

I have added a faux controller along with my controller and the models I set up in the layout tab will be one channel past the total channels of both controllers. So much more work than I remember from last year.

2

Do You Need Help? Post it here / Models not assigning to my 1 and only controller. What is happening?

« on: November 16, 2021, 10:41:57 AM »

I am running xLights ver. 2021.37 on a Mac and have a Falcon F16V3 controller with no expansions and/or serials. The controller is connected to Raspberry Pi 3B+ ver. 4.6.1.

I added my controller with the information selected. I think I have selected the correct information and boxes. I have attached a picture of my controller selection in xLights. I have it set to 96 universes and 510 channels per, obviously totaling 48960 channels.

In the layout tab any model I select and draw in the starting channel will go to 4896, no controller, no port selected. I have to add to port 1 or what ever number I want. Then I have to go to the controller tab, select my only controller, click on visualize, and assign each of the models to the controller one by one. If I did not enter a number for the port, while in the layout tab, the model will not show up in visualizer.

I have installed xLights and reinstalled. Deleted all files I could find with xLights information. I believe there is some deep rooted files that I cannot find because when I uninstall/reinstall the first boot up xLights is looking for my previous show folder. So that tells me files are somewhere deep in the terminal.

Any help is appreciated!
Thank you