Messages

1

Do You Need Help? Post it here / Re: Nodemcu running WLED with usermod for muli relay controls.

« on: April 10, 2022, 10:07:57 AM »

The problem I?m having is that Xlights only recognizes 3 ports for WLED controller. I tried putting the relays on the 3rd port but can?t figure out what model to use. If Xlights would allow me to use pwm white protocol it may work but I have tried all the protocols allowed on the controller and no luck.

2

Do You Need Help? Post it here / Re: Nodemcu running WLED with usermod for muli relay controls.

« on: April 06, 2022, 05:15:39 PM »

The controller in its native WLED app controls both the led lights and the relays. I would think that a simple on/off signal to a gpio pin wouldn?t be too difficult. But then again I know nothing about coding or how they actually work. Just learning as I go.

3

Do You Need Help? Post it here / Nodemcu running WLED with usermod for muli relay controls.

« on: April 04, 2022, 07:11:50 PM »

I'm running Nodemcu with WLED and a usermod for multi relay controls. The led lights are controlled through GPIO 2 and GPIO 1. The relays are controlled on GPIO 5,4,12, and 13. H Is it possible to control the relays through Xlights? If so how do I setup the controller. If not could this support be added? I have several dumb led static displays that I want to turn off with all the lights during a sequence.

4

Do You Need Help? Post it here / Nodemcu and universes.

« on: December 26, 2021, 05:25:56 PM »

Newbie here. Just started to build and test different models for future show next year. I built a 12 row by 24 column matrix for 288 nodes and a small 3 layer star 40/20/1 for 61 nodes total. Each model has its own controller Nodemcu/wled esp8266. the Matrix is set to universe 1&2 [1-1020] works fine. The star controller is set to universe 3 ch 1 [1021-1530]. Star model set to start channel #3:1(1021) #3:183(1203). When I start light all the light turn off so XL is controlling the lights through the controller however the star doesn't do anything. All works well through wled even syncs with matrix. When I had the star set to universe 1 and the matrix to universe 2-3 the star worked fine but the matrix only worked partially. seem that I can't get universe 3 to work. I even tried setting universe 3 through wled but nothing. Any help would be appreciated.