Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DaSarge

Pages: [1]
1
Do You Need Help? Post it here / Re: LOR Pixie16/Pixie2 with xLights
« on: December 01, 2023, 06:58:04 AM »
I think at this time I will run with LOR  :'( and next year get the F16V4 controller.  I just don't want to spend money again on renewing the license with LOR.  And with xLights I have tons more flexibility.  I do appreciate all the help here on the forum.  LOR was just an easy go-to not knowing the issues I would run into later down the road. 

I will look at my previous post earlier this year and see what he said.

Thanks!

2
Do You Need Help? Post it here / Re: LOR Pixie16/Pixie2 with xLights
« on: November 30, 2023, 06:57:49 AM »
Ok, thank you for the reply.
  1.  I have installed the 2023 version of xLights_64 
  2.  just watch the videos from 2020 to figure out how to get these 2 controllers to talk to xLights?
  3.  With using xLights I can finally use my Raspberry Pi's that I have to do much more.
  4.  Frustration is already starting :)

Just think of the song, "The 12 Pains of Christmas"  that is going thru my head as I attempt this leap of faith :)

Thanks!

Dave

3
Do You Need Help? Post it here / LOR Pixie16/Pixie2 with xLights
« on: November 29, 2023, 01:22:10 PM »
Greetings all!

  Looking to try to start a conversion from LOR over to xLights.  I currently use the S6 software (Pro Level) from LOR and I have a 16 Ribbon Mega Tree with CCR's, a Pixie16 controller drives the ribboms.  Up on the top I have a Star from SuperStar Sequences, it uses a Pixie2 with 2 channels with 2 strings of 50 Pixels each.  (200 Total) 

I want to go to xLights but not sure how to get all this stuff to work.  Any help here is greatly appreciated!

Thanks

Happy Lighting!

Dave

4
Do You Need Help? Post it here / Light o Rama controllers and xLights
« on: January 11, 2022, 08:07:18 AM »
Greetings all:
  Trying to get my LOR CCR controller and 2 port Pixie controller to work in xLights.  I looked at the manual and web items and I am unsure of where to go and turn to.  I want to go away from LOR and go to xLights.

Dave

Pages: [1]