Author Topic: Adjusting brightness to a finished sequence  (Read 2045 times)

Offline chadowamsley

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Adjusting brightness to a finished sequence
« on: July 08, 2016, 12:42:41 PM »
I seen a thread here, or on Facebook, talking about this subject. I can't find the post now and I was looking to see what went on with it.

I sequenced some songs already at 100 percent brightness, and after looking and reading I think I need to lower brightness. If  go into the model and adjust brightness, will that adjust the brightness for finished sequences and all new sequences after rendering ? If it works for finished sequences, it only applies to the max brightness and fades and morphs still remain unchangrd?

Thanks for any help. Images and stuff I used on mega tree I'm afraid will be to bright but to much work to have to change every effect or picture.

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: Adjusting brightness to a finished sequence
« Reply #1 on: July 08, 2016, 12:55:28 PM »
You will need to create dimming curves for each model you want to dim and then re-render/save all the sequences again.  The only other way is every effect can have a brightness.  Or you find a master brightness in something like the FPP player.

Offline chadowamsley

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Re: Adjusting brightness to a finished sequence
« Reply #2 on: July 08, 2016, 01:06:40 PM »
Ok I will take a look for the dimming curves and set those.

Appreciate the help.

Offline beatlerat

  • Jr. Member
  • **
  • Posts: 80
    • View Profile
Re: Adjusting brightness to a finished sequence
« Reply #3 on: July 19, 2016, 08:08:58 PM »
So a -20 on the dimming curve would be 80% of the maximum brightness?

Offline mararunr

  • Sr. Member
  • ****
  • Posts: 271
    • View Profile
    • Bentonville Heart Lites
Re: Adjusting brightness to a finished sequence
« Reply #4 on: July 20, 2016, 02:14:15 PM »
You can also probably change brightness on your controller if you want permanent dimming (as opposed to across individual sequences).
Bentonville Heart Lites (www.facebook.com/bheartlites)

Offline chadowamsley

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Re: Adjusting brightness to a finished sequence
« Reply #5 on: August 30, 2016, 07:33:56 PM »
Thanks for the replies, I had some issues come up that kept me tied up and have been unable to play with the lights.

Dimming curve, is that the brightness under gamma ? Just making sure before I do anything. I need to change brightness on my p10 panels and possibly my pixel tree if effects look to bright.

Offline kevinp

  • Sr. Member
  • ****
  • Posts: 373
    • View Profile
Re: Adjusting brightness to a finished sequence
« Reply #6 on: August 30, 2016, 09:08:12 PM »
Here's a good tutorial for adjusting your P10 panels...

https://www.youtube.com/watch?v=QtsncYoUl30
Kevin Pankratz
Blaine MN

Offline chadowamsley

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Re: Adjusting brightness to a finished sequence
« Reply #7 on: August 31, 2016, 07:05:40 PM »
Thank you for the video. I needed those baby step instructions.