P10 - so close

[Dave Nibeck]

Panel (2X3) tests ... something just not right.  See the ripple and marque effects.  I think I have it set up correctly but clearly I don't....

https://www.youtube.com/watch?v=KIj0pQiWzcs

[rando1957]

Dave - what does your LED Panels tab look like in the Falcon setup?  I had to play with my layout there to get my arrows facing right direction.

[Dave Nibeck]

I think I have it right...

[rando1957]

My start channel on the LED Panel screen is the same start channel as in XL and is the same on the FPP Universe screen as well.  In the Falcon setup you have channel 1 start but in XL you have 1038 (?? can't remember). Wonder if that is your problem?

[CaptainMurdoch]

Check the solder joints on your Octoscroller.  This looks like it might be an issue with one of the three address lines that select the row of the park that data is being sent to.  All outputs share the same address lines so it would affect all 3 outputs you are using.

[Dave Nibeck]

Thanks.  I don't see anything obvious but I'm not really sure I could tell unless is was really obvious.  I'll check with Todd at DIY to see if he will send a replacement.