tesxt on matrix

[Boof63]

HI i have 20st x 75pix matrix, using a pix 4 to ocntrol. in HLs all worked , however xl4 jumbled.
1 Checked wiring correct all good.
2 renderall in xl4 v53 - all good
3 changed start position - original top left, no good - other starting corners the same - no good
4 jumbled letters as if lines are synced together.
5 checked univerese pix 4 run 4 x 375 pix, setup for sequential channels- no good
5.1 setup for univerese ie 55-57 = output 1 start ch1
       "       "       "           58-60 = output 2 start ch1
       "       "       "           61-63 = output 3 start ch1
       "       "       "           64-67=  output 4 start ch1 

Letters stil are jumbled as are other effects - bars, stripes etc   

any solutions greatly appreciated  !!

+cheers Boof63 

[Phrog30]

How did you check the wiring? I would check by right clicking on the model in the layout tab and looking at the node layout. This is how xlights thinks it is. Then verify off of this.

To me, the best way to test is to drop on effects at the node level. Look on the preview for the node that is lit. Now look at the real lights. Is the same node on? Go through several nodes and verify. My guess is you will see where things aren't correct.

James


Sent from my Pixel using Tapatalk

[Gilrock]

The quickest way to solve this is show a screenshot of the controller setup, the xLights model properties for that matrix, and the setup page in xLights,

[Boof63]

Thanks for reply guys , got to nutted out, needed to setup controller exactly as xl4 setup
Ie output 1 uni 1  510 ch , uni 2 510ch , uni 3 106 ch. ( total pix count 375. / ch 1125. Per output)
   Output 2 uni 4 510 ch , uni 5 510 ch , uni 6 106 ch..
Etc for next  2 outputs .........
Hope this helps someone else
And thanks for replies fellas
Cheers boof👍63