« previous next »
Pages: [1]   Go Down

Author Topic: E682 not working  (Read 1534 times)

Offline ranjanpa

  • Full Member
  • ***
  • Posts: 118
    • View Profile
E682 not working
« on: December 17, 2016, 05:39:27 PM »
Today half the channels in my e 682 went blank. I am now panicking as the show is on. Anything to do with the sub zero weather in Chicago. Anybody with similar experience pls advice. Thanks


Sent from my iPhone using Tapatalk
Logged

Offline emkllk

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: E682 not working
« Reply #1 on: December 17, 2016, 08:36:04 PM »
When you say half the channels, are you referring to the output banks?  Would that mean that outputs 9-18 aren't working?  Or is it some other grouping.  When you say they went blank do you mean they are not responding to your sequence events?


Sent from my iPhone using Tapatalk
Logged

Offline ranjanpa

  • Full Member
  • ***
  • Posts: 118
    • View Profile
Re: E682 not working
« Reply #2 on: December 17, 2016, 11:13:05 PM »
Yes channels 1 to 8 do not output lights. They were fine for the past two weeks.


Sent from my iPhone using Tapatalk
Logged

Offline danj

  • Hero Member
  • *****
  • Posts: 895
    • View Profile
Re: E682 not working
« Reply #3 on: December 17, 2016, 11:32:00 PM »
Outputs 1-8 are powered by the left-most power input terminals on the circuit board and outputs 9-16 are powered by the right-most power input terminals on the circuit board.   I recommend putting a meter on your left-most power input terminals and see if you have voltage there.   You might want to post over at DIYC forum; there are more E682 users over there than here.
Logged

Offline ranjanpa

  • Full Member
  • ***
  • Posts: 118
    • View Profile
Re: E682 not working
« Reply #4 on: December 18, 2016, 06:09:48 AM »
Ok thanks Danj


Sent from my iPhone using Tapatalk
Logged
Pages: [1]   Go Up
« previous next »