Author Topic: WS2811 strand won't come on  (Read 2423 times)

Offline ttwiss

  • Newbie
  • *
  • Posts: 17
    • View Profile
WS2811 strand won't come on
« on: December 05, 2016, 12:12:52 PM »
I'm hoping someone will have some insight for me.  I have one wreath that I have 100 ws2811 pixels on that won't light up.  I am running it off of a sandevices e682.  All of the rest of the show is working except this one wreath.

- Tested the output with another wreath- works fine.
- Checked the fuse- OK
- Tested straight from the sandevices interface- does not come on (all other outputs come on)
- When I first connect it- all the lights flicker so I know it is getting power.

Any chance the pixel data chip is bad on the first pixel??  Any help would be greatly appreciated.

Offline jnealand

  • Hero Member
  • *****
  • Posts: 1421
    • View Profile
Re: WS2811 strand won't come on
« Reply #1 on: December 05, 2016, 12:16:41 PM »
Or could you be connected to the data out side of the string?
Jim Nealand
Kennesaw, GA

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: WS2811 strand won't come on
« Reply #2 on: December 05, 2016, 01:02:43 PM »
I've seen it be several things.  Yes it could be a bad pixel.  It could be miswired from the manufacturer.  I had one string I saw work this weekend and then after troubleshooting something that string quit working.  I cut out a couple pixels and it still wouldn't work so I can only assume I fried all the pixels somehow.

Offline ttwiss

  • Newbie
  • *
  • Posts: 17
    • View Profile
Re: WS2811 strand won't come on
« Reply #3 on: December 05, 2016, 01:03:02 PM »
I don't think I'm connected to any other data out side of that string.  I switch the input plugs on the e682 and no lights to the problem strand.

Offline ttwiss

  • Newbie
  • *
  • Posts: 17
    • View Profile
Re: WS2811 strand won't come on
« Reply #4 on: December 05, 2016, 01:08:15 PM »
I've seen it be several things.  Yes it could be a bad pixel.  It could be miswired from the manufacturer.  I had one string I saw work this weekend and then after troubleshooting something that string quit working.  I cut out a couple pixels and it still wouldn't work so I can only assume I fried all the pixels somehow.

Yeah it worked just fine when I tested it before connecting the whole display.  I can't figure out what happened!

Offline ttwiss

  • Newbie
  • *
  • Posts: 17
    • View Profile
Re: WS2811 strand won't come on
« Reply #5 on: December 05, 2016, 02:00:22 PM »
I think I may have figured it out!  I replaced the european connector to the e682 and it works again.  Perhaps it wasn't connected properly there.  But now it works.  Now I have to redo my connections that I took apart testing everything. But it should work again!