Having issues resizing a model

[caniac]

can't get it to shrink to fit where I want it.

[Phrog30]

Probably not putting enough effort into it. I'm basing that off of your posts, just a couple of words, no pictures, no videos. Download the manual and watch some videos. Then if you are having problems spend a little more time explaining your problem.

Sent from my Pixel using Tapatalk

[caniac]

Probably not putting enough effort into it. I'm basing that off of your posts, just a couple of words, no pictures, no videos. Download the manual and watch some videos. Then if you are having problems spend a little more time explaining your problem.

Sent from my Pixel using Tapatalk

Not due to lack of effort, when highlighted you should be able to go to the corners where you have a bidirectional arrow and either expand it or shrink it.  Do not appear to be working, reading manual and watching videos doesn't fix it.  Neither does sarcasm.

[jnealand]

I have a similar problem.  Gil suggested quit using the corners and use the keyboard or type a number in the model boxes.

[caniac]

I have a similar problem.  Gil suggested quit using the corners and use the keyboard or type a number in the model boxes.

Not pretty but it works, thanks.

[Phrog30]

Neither does sarcasm.

I wasn't going for sarcasm.  You have already made it clear in a previous post that you are far too busy to figure this stuff out (I'm paraphrasing).

[Gilrock]

I've never seen a problem using the corners except I believe one instance where someone uses a PolyLine and places points at the same spot at the overall bounding box.  There is an issue request in the fix that one.  Other than that I'd love to see a video showing the issue.  Several free programs like Screencast-o-matic could create a video.