Well I made a crossover cable, Renard Blue/White to Falcon Orange/White and Renard Blue to Falcon Orange. They communicated, for a while, then the communication stopped. While they were communicating, a couple of strings of lights (out of 4) worked properly, but two never came on at all. I tried doing some reconfiguring in Xlights & on the Falcon Interface, but nothing helped. Then, they stopped communicating. The cable looks correct, I even took the cable apart and rewired, but nothing. I don't know where to go from here. All I need is something that will work with Xlights and the Falcon 16v3. All of my lights are smart RGB except the roof line and the strobes, these strings are C-9 LED's and the strobe is just 4 LED floods on one strand. I have the roof outlined in 3 sections and then the strobes. All I need is something that will turn those 4 strands of lights on and off. What can I find that will do this and works with Xlights & the Falcon controller? I'm sorry I'm getting wordy on this, but I've been doing my light show for 4 years and I've never been able to get these 4 strings of lights to work. I've got an LOR controller that I've tried and couldn't get them to work, so I've just been leaving them on during the show. I bought this Renard this year and was hopeful it would work, but I don't think it's going to. Any advice on setting the Renard up or just buying something that I can plug into the Falcon and make it work.
