Hey All,
This is probably not a bug and most can likely figure it out but it tripped me up for a bit and might others as well so I thought I'd post about it.
After updating to the latest version (.52) I went back and played a sequence to test just to make sure everything upgraded... In preview it appeared my setup or models were off as the pixels seemed to bleed off the far right of my house model onto the left of the model....and my MT had things positioned higher on the tree than before the upgrade. The funny thing is this did not happen on all my 'finalized' sequences....just some.
I checked layout first on one sequence that was acting up and couldn't find anything so as I was thinking about it I hit 'refresh all' and suddenly everything went back to normal and now works as before. This is not a big deal if you are aware enough to refresh all. I guess it might be a good idea to go back and do that following an upgrade but wasn't something I had automatically done in the past as it never seemed to be a problem.
Now....I'm not sure if this showed up in .51 or .52. When I upgraded to .51 I tested 1 sequence and it worked but it could be that I just happened to pick one that was okay..... I know they were all working on .50.