Hello
I'm new on this forum, I'm living in the south of France and I discovered Pixels ,controllers and lights last year.
Last christmasy I ran my first pixel show, it worked perfectly but was a little bit a simple one.
I run a F16v3 with 2 differential expansion board controlled by a Pi, my display is composed by
a mega tree 2400 pixels, 4 arches, 6 circles (700 nodes) 11 stars 10minitrees with mini stars 5 candy canes Singles lines on the roof, 12 singles lines
My question today (hope my english is good enough to explain clearly my pb) I began several weeks ago a musical show (French version of let it go from frozen) and it is almost finished. but today to fulfill what I want to do I cut a single line of 150 nodes into 3 of 50 nodes. They appear in the layout of Xlights but when I load the sequence I did save before these 3 lines don't appear, the only first one is on the list of display
Is there a simple method to get my changes of display so I can go on and finish my sequence without doing it again since the beginning totally.
This software is fantastic
Best regards from France
