« previous next »
Pages: [1]   Go Down

Author Topic: LOR and setup question  (Read 764 times)

Offline Ralph D

  • Newbie
  • *
  • Posts: 31
    • View Profile
    • Christmas On Manhattan
LOR and setup question
« on: February 18, 2018, 09:35:46 AM »
Hi everyone,
so is there a newer video of how to setup LOR controllers in Xlights. I was hoping to connect to my lor boxes through my falcon controller, so has anyone made or seen a video specific to showing what i want to do? 

2nd, When putting my LOR-AC channels into xlights setup section... am i choosing the DMX option? and does that mean they don't need a universe number.  sorry for the repetitive questions but I am just confused about this part.

Thanks So Much,

Ralph
Logged
Merry Christmas,

Ralph Deweil
Ralph@christmasonmanhattan.com
www.christmasonmanhattan.com

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: LOR and setup question
« Reply #1 on: February 18, 2018, 11:19:17 AM »
No you need to set them up as E1.31 and assign a universe.  Then in the Falcon you will set it up to send that universe out the DMX serial port.
Logged

Offline Ralph D

  • Newbie
  • *
  • Posts: 31
    • View Profile
    • Christmas On Manhattan
Re: LOR and setup question
« Reply #2 on: February 19, 2018, 01:40:37 PM »
Thanks so much!!!!!
Logged
Merry Christmas,

Ralph Deweil
Ralph@christmasonmanhattan.com
www.christmasonmanhattan.com

Offline Todd

  • Newbie
  • *
  • Posts: 9
    • View Profile
Re: LOR and setup question
« Reply #3 on: February 27, 2018, 04:10:02 AM »
Make sure you have the correct firmware on the LOR controllers or they will not work in DMX mode


Sent from my iPhone using Tapatalk
Logged
Pages: [1]   Go Up
« previous next »