Author Topic: .56 copy and paste issue  (Read 632 times)

Offline poporacer

  • Full Member
  • ***
  • Posts: 184
    • View Profile
.56 copy and paste issue
« on: December 17, 2018, 03:37:41 PM »
I was working on a sequence and had a few sections that I was copying and pasting, and then the copy function quit working. It was like the clipboard would not accept the new selection and kept pasting the previously copied effect. I saved the sequence, and got the same results. I tried this several times just in case I wasn't capturing things correctly. I was only able to fix it by closing the program and opening it back up. Here is a video showing the problem.

Offline poporacer

  • Full Member
  • ***
  • Posts: 184
    • View Profile
Re: .56 copy and paste issue
« Reply #1 on: December 17, 2018, 04:13:32 PM »
I think I found the issue but not sure if you want to address it. When I was copying, I was actually selecting above the area that I wanted selected which was on a timing track and it was copying effects that were not visible. It was copying every effect for that timeframe.