Author Topic: xLights Output to Tune To Sign  (Read 496 times)

Offline feeleyfam

  • Newbie
  • *
  • Posts: 22
    • View Profile
xLights Output to Tune To Sign
« on: October 12, 2020, 05:31:26 PM »
I have a Tune to Sign made with two P5 panels side by side. This is being run by a colorlight card and a raspberry pi using FPP. I have tested the sign in FPP and in LEDVision for the Colorlight card and everything is good. I am using DDP Protocol in xLights. It is showing on my House preview but not outputting to the sign. I am having an issue with connecting to the Pi with the assigned IP address. The only way I can access it is if I disconnect my Matrix, which is also using a Pi, and use FPP. Not sure why this is happening but I verified all the IP addresses in the Pi and compared them to my Matrix. I am thinking this is the issue but I can't figure out why. If anyone has any ideas, please pass them along.

 
« Last Edit: October 12, 2020, 05:33:16 PM by feeleyfam »

Offline keithsw1111

  • Administrator
  • Hero Member
  • *****
  • Posts: 2733
    • View Profile
    • Kellyville Christmas Lights
Re: xLights Output to Tune To Sign
« Reply #1 on: October 21, 2020, 04:01:27 AM »
Problems like this are best solved in the zoom room.

Offline feeleyfam

  • Newbie
  • *
  • Posts: 22
    • View Profile
Re: xLights Output to Tune To Sign
« Reply #2 on: October 21, 2020, 07:21:53 AM »
Thank You Keith. Once I have some time, I will connect to the Zoom room.

Offline feeleyfam

  • Newbie
  • *
  • Posts: 22
    • View Profile
Re: xLights Output to Tune To Sign
« Reply #3 on: October 23, 2020, 10:47:24 AM »
Update! So I started one more time from scratch and set everything back up and it started working. I could connect to FPP through IP address and was able to upload to the Pi from xLights.