« previous next »
Pages: [1]   Go Down

Author Topic: *Solved* Tune To Sign Start Position  (Read 820 times)

Offline feeleyfam

  • Newbie
  • *
  • Posts: 22
    • View Profile
*Solved* Tune To Sign Start Position
« on: November 30, 2020, 08:13:21 PM »
I have my P5 Tune To sign placed in my yard and somehow between taking it from the house to the yard, I have noticed the start position of the scroll is wrong. Everything displays fine on the preview in xlights but out at the sign, everything is shifted to the left. This is being run with a Raspberry Pi and Colorlight card. I can't seem to find a setting in FPP or in xlights to make this correction. If anyone has any ideas, I'd greatly appreciate it. I have included a photo of the display.
« Last Edit: December 11, 2020, 06:56:00 AM by feeleyfam »
Logged

Offline kenoman742

  • Newbie
  • *
  • Posts: 37
    • View Profile
Re: Tune To Sign Start Position
« Reply #1 on: December 01, 2020, 09:48:14 AM »
I think your issue is most likely in the panel setup area in fpp. I would play with the options in the Panel Interleave area.
Logged

Offline feeleyfam

  • Newbie
  • *
  • Posts: 22
    • View Profile
Re: Tune To Sign Start Position
« Reply #2 on: December 01, 2020, 11:53:16 AM »
Thanks for the advice. Unfortunately, I looked around in FPP and since I am running this on a Pi, they do not have this function. I messed around with other stuff in there to no avail. I'll keep on trying to figure this out.
Logged

Offline feeleyfam

  • Newbie
  • *
  • Posts: 22
    • View Profile
*Solved* Tune To Sign Start Position
« Reply #3 on: December 11, 2020, 06:54:21 AM »
Finally found the issue. The Start channel in FPP was a few channels off from xlights for some reason causing the start location on the sign to be later.
Logged
Pages: [1]   Go Up
« previous next »