question on layout of prop that goes over 512 channels

[tractormike21]

I have a prop with 290 pixels.  My plan is to run off of 2 ports, with appropriate power injection.
1 port will have 100 pixels.  1 port will have 190 pixels on it.
The prop is a Holiday coro 36 inch 6 row star.
If I follow their wiring, but run the first strand past where they suggest, since the recommend 3 ports, and then start the next strand and the third, will I be able to setup the prop in Xlights like I am used to as a 6 row star, and then connect the strands to the ports in the visualizer, will it work properly.

I should know this, but I want to make sure before I push all those pixels:)

Thanks,

Mike.

[Gilrock]

I really don't know I've not used the visualizer.  Why not just try to set it up and find out?

[keithsw1111]

As long as it is a custom model set the number of strings and define which node is the first on each string. Then you can adding the prop in the visualiser.

[tractormike21]

Thank you Keith,

That is what I seemed to remember, but I wanted to check.
Like I said, it is a 36 inch corostar with 290pixels and instead of 3 ports, I only have 2 to run it off of.

Have a Merry Christmas!

[Gilrock]

I personally have two of those in my show and each one runs off of a single port.  I run at 30% to stay under 5 amps and I parallel the power into 4 spots at the entry point of the star.  I call it localized power injection.

[tractormike21]

Thank you for the input.

Again, I wanted to check before I started pushing pixels:)