I'm trying to get my Sandevices 682 controller to drive my Renard ss24 controller. I've read the instructions on how to wire it up. I have ports 4-1 thru 4-4 set as Renard on the 682 and have the jumper set correctly. It's setup as universe 100, starting at channel 1...and 24 channels total But I cannot get my test sequence to work on Xlights. I have the controller setup in xlights as a E131 controller at the same address 192.168.1.215, but xLights does not seem to have the ability to set certain ports on the Sandevices to type Renard. Can anyone tell me if this is supported? It seems XLights does have a setting for the controller Port, Protocol and Channel, but it seems busted and seems to assign the model to some non-existent serial port instead of the port I am using port 4-1 on the Sandevice.
