« previous next »
Pages: [1]   Go Down

Author Topic: Lynx Dongle setup  (Read 1415 times)

Offline jeffl

  • Full Member
  • ***
  • Posts: 146
    • View Profile
Lynx Dongle setup
« on: December 20, 2015, 04:42:50 PM »
I tried to setup a lynx dongle in xLights and it was on Com12 in device manager.  In xLights Com1-9 look normal but Com12 is:

\\.\Com12

Is this correct?

Pic is attached.

Thanks

Logged

Offline t.jo13t

  • Jr. Member
  • **
  • Posts: 55
    • View Profile
Re: Lynx Dongle setup
« Reply #1 on: December 20, 2015, 05:04:59 PM »
My usb dongle is set up for com 3  and all it shows on the dropdown menu is com3 none of the slashes and such in front like you have.
Logged

Offline jeffl

  • Full Member
  • ***
  • Posts: 146
    • View Profile
Re: Lynx Dongle setup
« Reply #2 on: December 20, 2015, 06:05:39 PM »
That's what I'm puzzled by.  1-9 show normal 10-20 are goofy.  Another pic is attached.
Logged

Offline jnealand

  • Hero Member
  • *****
  • Posts: 1421
    • View Profile
Re: Lynx Dongle setup
« Reply #3 on: December 20, 2015, 06:07:15 PM »
Can you force your dongle to com9 or less?
Logged
Jim Nealand
Kennesaw, GA

Offline jeffl

  • Full Member
  • ***
  • Posts: 146
    • View Profile
Re: Lynx Dongle setup
« Reply #4 on: December 20, 2015, 07:08:49 PM »
Thanks.  I used this link to show unused ports and remove them down to Com3 which I assume will work. 

http://theitbros.com/how-to-delete-com-ports-in-use/
Logged
Pages: [1]   Go Up
« previous next »