« previous next »
Pages: [1]   Go Down

Author Topic: sequencing Dumb 5050 RGB  (Read 804 times)

Offline mmais

  • Full Member
  • ***
  • Posts: 212
    • View Profile
sequencing Dumb 5050 RGB
« on: February 11, 2018, 01:12:33 PM »
Is there anyway to sequence 5050 dumb strips. I am coming over from LOR this year & can not afford to change everything to Pixels this year. I have 8 5050 RGB arches I would like to use this year if I can sequence them.
 Thanks Mike
Logged

Offline keithsw1111

  • Administrator
  • Hero Member
  • *****
  • Posts: 2733
    • View Profile
    • Kellyville Christmas Lights
Re: sequencing Dumb 5050 RGB
« Reply #1 on: February 11, 2018, 03:01:31 PM »
Sure. You just need a suitable controller like a 27 or 30 channel dmx controller.


Sent from my iPhone using Tapatalk
Logged

Offline mmais

  • Full Member
  • ***
  • Posts: 212
    • View Profile
Re: sequencing Dumb 5050 RGB
« Reply #2 on: February 11, 2018, 03:04:11 PM »
I have the 27 ch controller & have set the DMX addresses But can not figure out how to get it into xLights.
Mike
Logged

Offline keithsw1111

  • Administrator
  • Hero Member
  • *****
  • Posts: 2733
    • View Profile
    • Kellyville Christmas Lights
Re: sequencing Dumb 5050 RGB
« Reply #3 on: February 11, 2018, 06:32:34 PM »
How did you connect the controller. To a USB dongle or to another controller.


Sent from my iPhone using Tapatalk
Logged
Pages: [1]   Go Up
« previous next »