Running LOR controllers in xlights

[Sirgen]

Ok ao i deleted all my playlists and started from scratch , rebooted my computer, and just made an all on all channel sequence in xlights. Opened it in xschedule, and ran it and about 1/2 of my lor controllers lights came on, i was so excited, so i ran it again so I could run out side and see exactly what was on and what wasnt, and none of them came on this time. I looked at the log and I dont see any difference but have attached it to this post, thoughts?

[keithsw1111]

You really need to take the FSEQ out of the process. Set up an advanced playlist and add a test item and test all the channels. This will ensure data is being written out.

[Sirgen]

So I did what you suggested and set up the test,  my lor props are a mix of led and incans, as well as some RGB floods. I set it up for value 1, and value 2 with no lights, but when i changed to A,B,C and A, B,C All all lor controllers lights, LED, Incans and RGB as well as my e131 tree and star come on , although they flash on and off. So i am not sure what this means , since there is no FSEQ in in, what is wrong with my FSEQ files?

[keithsw1111]

You really need to get yourself into zoom so someone can help you in real time. In xlights go to the help menu and click zoom. Make sure you have a microphone connected to your computer and ask your question there.


Sent from my iPhone using Tapatalk

[Sirgen]

So i did the test, and now started adding fseq one by one and now it all works, even sending data through my lor ELL wireless linkers, so i i don't know what the issue was but im going to build a schedule and see how it goes. Thanks si much fir all your help, this site is great for all the help people offer even in this busy time!