« previous next »
Pages: [1]   Go Down

Author Topic: Simulate sweeping light beam over house model.  (Read 614 times)

Offline esset

  • Newbie
  • *
  • Posts: 27
    • View Profile
Simulate sweeping light beam over house model.
« on: September 01, 2019, 02:56:26 PM »
Hi, I would like to simulate a sweeping light beam to my house model from a centerpoint bouncing from left to right. Is that possible with xlights?
Logged

Offline charlie-68

  • Full Member
  • ***
  • Posts: 181
    • View Profile
Re: Simulate sweeping light beam over house model.
« Reply #1 on: September 02, 2019, 05:24:20 PM »
You might try a fan effect with two blades. you can position the center point any where. I have a similar effect in my sequence. Make sure you straighten the blades.
Logged

Offline charlie-68

  • Full Member
  • ***
  • Posts: 181
    • View Profile
Re: Simulate sweeping light beam over house model.
« Reply #2 on: September 02, 2019, 05:33:03 PM »
This is a correction to my post, it's not the fan effect but the pinwheel effect.
Logged
Pages: [1]   Go Up
« previous next »