Author Topic: Lor controller setting Layout Tab  (Read 666 times)

Offline Tatankawij

  • Newbie
  • *
  • Posts: 11
    • View Profile
Lor controller setting Layout Tab
« on: October 23, 2019, 11:21:48 AM »
In the Layout Tab, Controller Setting for LOR The program asks for port number, protocol, and channel number.
I am running XLIGHTS .59, through a Falcon F16v2R controller, to my LOR boxes configured for DMX channel numbers 1 through 48.
Do I use the Serial port number I am hooked into? Which is 2 ?
I can play my sequences when I output directly from computer, but when I use XSCHEDULE, about half of Pixels light up.
I have found some pixel settings which are wrong.
Thanks Joe

Offline dm9991966

  • Newbie
  • *
  • Posts: 15
    • View Profile
Re: Lor controller setting Layout Tab
« Reply #1 on: October 23, 2019, 12:46:15 PM »
I've got an LOR controller running off an F48, and yes, the Controller port should be the serial port on the Falcon controller the LOR is connected to, the protocol should be DMX, and the channel should be the appropriate DMX channel.  For LOR ID 1, the DMX channel would be 1-16, LOR ID 2 would be for DMX channels 17-32, etc.

LOR has a DMX document http://www1.lightorama.com/Documents/DMX-DOC.pdf that maps the controller IDs to the starting addresses

Trace Wilson
Jacksonville, FL

Offline Tatankawij

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: Lor controller setting Layout Tab
« Reply #2 on: October 23, 2019, 01:52:31 PM »
Thanks a Bunch Trace !!

Joe Dudley
Silverthorne, Colorado