Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jonnyci

Pages: [1]
1
Do You Need Help? Post it here / Re: Upside Down Images
« on: November 14, 2015, 06:03:03 PM »
Gilrock

I have my megatree defined as starting bottom left in both Xlights and LOR, so that is why I am baffled as to why they are only appearing that way after I convert them in Xlights. 

I will keep trying.  IDK though ???

2
Do You Need Help? Post it here / Upside Down Images
« on: November 14, 2015, 03:45:21 PM »
I was wondering if anyone could help me in regards to what is going on, or what I have set up wrong, once I attempt to convert my saved .fsq sequence to .lms
Every time I open a converted sequence in the LOR sequencer the images are upside down.  I don't know if this is how they are going to display on my 16 strip mega tree or not, but I would imagine so.   Everything plays fine and displays properly in Xlights.  This happens with a sequence I purchased from holidaysequences.com as well.  The original plays fine LOR, but if I import it into Xlights and then convert it back to .lms the images are backwards.

Thoughts?

Thanks!
Jon

3
Xlights Setup / Re: Pixlite 16 and Xlights
« on: December 21, 2014, 03:51:25 PM »
I don't think I have done that, since I am not sure where those settings are..

4
Xlights Setup / Pixlite 16 and Xlights
« on: December 21, 2014, 02:25:03 PM »
Was wondering if anyone could provide any help with my mega tree setup. I purchased the Pixlite 16 and 12 strip package from Holiday Coro.  I have each strip set up on a single output on the board.  I am only getting output on my strips on the first 7 and the first set of pixels on number 8.
I tried changing my starting universe and got less output on my pixels.
When I put the Pixlite in test mode all of my strips light up and cycle through red, green, blue and white.

Any thoughts on where I should start looking as to where my setup is wrong?   

Thanks!


5
Show Assets / Re: couple to share
« on: November 05, 2014, 03:21:38 PM »
Can I ask how you get the XML file into Nutcracker?

Pages: [1]