Messages

1

LOR / X Lights to LOR lms file

« on: February 19, 2018, 10:12:11 AM »

When converting Xlight sequence to LOR sequence lms  how come the universe and channels don't carry over to lor sequence  do you always have to add channel config to sequence after converting  thanks Dennis

2

Lights / Re: pixel wire lenght

« on: January 27, 2014, 03:12:29 PM »

Thanks I thought their was a limit just didn't know for sure   

3

Lights / pixel wire lenght

« on: January 27, 2014, 01:13:17 PM »

I have 12volt c9 smart pixels from seasonal entertainment  2801   I would like to cut the string at 14 pixels and add a section of wire of 5ft between 14 and 15 pixels and again the 28 pixel can I do that distance or will that screw up the data signal  thanks Dennis

4

General hardware / Re: Is anyone building their own laser shows?

« on: January 23, 2014, 01:43:20 PM »

Hi Sean I have bought the Pangolin Quickshow software and have had it for two weeks now. seems to be pretty easy to use however in order to sink with other programs like lor you would need to upgrade to the next software level which is fairly expensive.  just received my projector today check for my answer to your same question in planet Christmas forum for what I have  Thanks Dennis Laff

5

General hardware / Re: Can't make pixel tree work?

« on: January 20, 2014, 06:29:44 PM »

In lor did you set the network preference to E1-31 and add the ip address

6

General hardware / Re: Can't make pixel tree work?

« on: January 20, 2014, 04:21:49 PM »

Did you set the ip address for the controller to match ip address of your lan line

7

Xlights Setup / Re: Using xlights /nutcracker

« on: January 14, 2014, 03:51:50 PM »

Hi Sean Thanks for the reply looks like my problem is with the latest version when I downloaded version03.03.00 yesterday is when screen froze  when I went back to version 03.02.14 it s ok tried to go back to version  03.03.00 screen freezes up swiched back to version 03.02.14 everything ok  .One more question when using audacity for timming marks of song what flie do you save timming to Thanks Dennis

8

Xlights Setup / Using xlights /nutcracker

« on: January 13, 2014, 06:33:22 PM »

Using xlights /nutcracker right now  its acts like it froze up wont let me add rows. now both play buttons say  sequence f3 on effects builder on sequence play say f4  can't get to go off so I can add rows never had this problem before anybody have an idea what to do Thanks Dennis

9

Xlights Setup / Re: Second topic

« on: January 13, 2014, 05:38:38 PM »

Just signed on but have been using nutcracker form the start