Messages

1

Xlights Setup / Com port problem

« on: October 14, 2017, 05:08:10 PM »

This may be a Windows problem. I have holidaycoro dmx dongle. Plugged it in and the windows Device manager shows Dmx Pro, no com/printer. No place for to select a com port number.
Q: Is there a different setting for xlights.

2

Do You Need Help? Post it here / Setting up CCR's in Xlights off of a Falcon16 v2

« on: August 12, 2016, 04:10:20 PM »

I have not had much luck setting up LOR CCR's in DMX mode off of a Falcon 16 v2. I have 4 CCR's (Unit 7,8,9, 0A). I have set the falcon firmware for DMX out of DMX1. Use a net cable to LOR crossover to CTB16. Net cable to CCR 7. Net cable to CCR8 and so on. Setup Xlights with Universe 1 for LOR. Setup model for the CTB16 (16 single channels) (Everything OK). Set up first CCR (Unit7) on dmx address 97. That did not work. Tried address 113, and ok. Now here is the hard part. I cannot find where the set the next dmx address for CCR unit 8. Nothing seems to work. Any ideas!!! LOR manual for CR150 ccr on page 33, Appendix A: Lor unit id 1=dmx1, lor unit 7=dmx 97, lor unit 8=dmx 113. Not sure how you get 150 channels of dmx out of this setting.
Thanks Bill