Messages

1

Xlights Setup / Re: Out put configure

« on: October 25, 2017, 05:21:24 AM »

I do this in xlights or to the controler?

2

Xlights Setup / Out put configure

« on: October 24, 2017, 09:34:59 PM »

Ok I have alpha pix 16 I read it can handle 340 pixels per out put so I re did all my matrixes to save channels instead of buying more boxes now in xlights it only allows me to go to 512 or 170 anyone have any tricks

3

Xlights Setup / added alpha pix 16 controller having issues all over now

« on: November 27, 2016, 10:42:01 PM »

I set up for Halloween everything ran fine Christmas comes I add more stuff it all works fine...I had a lot set aside for parade so I added all this and I'm having issues all over since adding my 4th box I don't think 4 is a lot everything works fine alone but as a group I get blinking freezing wrong colours I have sufficient power to everything is it possible therected to much data....I'm running uni cast is the a signal booster or something I don't want to program around flaws and flaws drive me nuts

4

Do You Need Help? Post it here / Wrong color

« on: October 20, 2016, 06:11:27 PM »

I have a problem addressing color as in ok I have pixels which are rgb order and I have Holliday coro alpha pix controller out put 1 is rgb now out put 2 is wrong color is this an xlights setting or my controller I test controller and every output runs the colors properly....as now I have 1 older box I updated firmware and I can't change rgb addressing differently for each output...helllllp