Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - regawthr

Pages: [1]
1
Xlights Setup / Re: Sequence Pausing
« on: December 04, 2018, 09:17:34 PM »
Hi Keith,

I had the lagging issue.  I sent the log file to you via FB messenger. 


2
Xlights Setup / Re: Sequence Pausing
« on: December 04, 2018, 12:34:22 PM »
Ok if I can catch the lagging I will jump on zoom later on at night. I appreciate the help

3
Xlights Setup / Re: Sequence Pausing
« on: December 03, 2018, 11:26:40 PM »
Hi Keith
Sorry my laptop battery died so I lost the zoom meeting. I ran through 3 shows cycles with no lag so perhaps the upgrade to v 51 did the trick. I’m wondering if I should leave the log file in debug for a while in case the magnet comes back. That way I can not the time and reference it to the log. Does that sound like a good idea?

4
Xlights Setup / Re: Sequence Pausing
« on: December 03, 2018, 06:28:13 PM »
I still have the pausing on vs 51.  I checked and she had wifi on when checking earlier, the network usage was on 4% when running the show with wifi off.


5
Xlights Setup / Re: Sequence Pausing
« on: December 03, 2018, 05:41:07 PM »
HI Keith,
We upgraded to .51.  I had my wife run the show during the day and the interesting part is that in task manager the network was showing 97-98% utilized when running the show.  She didn't let it run for long enough to see if it was pausing.  I'm going to try that in just a bit.

thanks

6
Xlights Setup / Sequence Pausing
« on: December 02, 2018, 10:08:08 PM »
I’m having lagging issues in my show. The lagging seems to get worse after the scheduler (xscheduler) loops through the show a few times. The show is pausing about every 1-2 seconds. My display is all pixels and run via 4 alpha pix and 2 falcon controllers in unicast. I have tested every sequence and only have a few small warnings for blocks of unused channels. The blocks are fairly small. My props are all mapped to universe and start channel. I run the show on a separate network from my home and I have WiFi turned off on my laptop when the show is running.

Also, i don't get any lagging when playing a sequence in xlights sequencer and outputting to lights.

Any suggestions to try are greatly appreciated.

Pages: [1]