Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mattokc

Pages: [1]
1
Do You Need Help? Post it here / 1200 Pixel matrix in xlights
« on: December 01, 2021, 04:17:23 PM »
Having trouble not sure how to fix this in Xlights.  I have a 1200 pixel matrix that I am trying to set up. In xlights software how do I configure this with Falcon F16v3 since each port is only 1024 max? Not sure if it matters but the board in split into 2s 600 top /600 bottom. Not sure if I need to run virtual strings or how to go about this.

2
Xlights Setup / Re: PixCon16 Setup
« on: June 24, 2020, 03:35:11 PM »
Thanks for the response. I tried to use the Advatek assist with no luck. I did want to clarify that this is the Pixcon16 and not the Pixie board, Iam not sure if that would still work or does it make difference. The Push config I will have to read up on so that I know whats going on.

3
Xlights Setup / PixCon16 Setup
« on: June 24, 2020, 02:10:55 AM »
Iam new to the Hobby this year and I bought a pixcon16 not knowing anything about it like I should. Anyways is there a way to configure this board without using LOR Software? Can I just set it up on Xlights. As of now I really do not know if the board is working like it should or not.. Ive done the whole Ipv4 changes etc I simply cannot see this board on my network. I was unaware of things and only have the Basic lor software for 2ids, Pro/Advance is needed.. LOR is  not much help and I cant find any forums that really answer my question. Any help would be great. Remember Iam new so I might not know the correct terminogly.

Pages: [1]