Upload Failed, but it didn't really

[JeffL98]

I uploaded outputs to F48 and received "Falcon Output Upload Failed" in xLights, but on the F48 strings page, the upload actually succeeded. Is this failure reported because I did not completely use all of the outputs? I only used 1-19 of the 48 outputs for this test. Outputs 20-48 are shown in red with "invalid" values so assuming that's the reason it's reporting as failed. 1-19 are all good with the correct data.

[keithsw1111]

Did you upload inputs first

Did check sequence give you any errors.


Sent from my iPhone using Tapatalk

[keithsw1111]

Log file will tell you why it failed.


Sent from my iPhone using Tapatalk

[JeffL98]

Check sequence is fine and I don't see any errors in the log (attached).

[keithsw1111]

Ok ... odd error: Falcon Outputs Upload: 192.168.1.3 V2 Controller only supports one expansion board.

But you seem to be only using 19 outputs so not sure why that error was logged.

Need to look into it.

[JeffL98]

My guess is that the invalid config for ports above 19 are what's tripping it up.

Would you like me to file a bug on GitHub?

[keithsw1111]

You would have to have configured a port for 33+. But I didn’t see that. I will look in the next few days.


Sent from my iPhone using Tapatalk

[keithsw1111]

This should be fixed in .18

[keithsw1111]

Spoke too soon. It’s better but not fixed. Looks like it will be .19


Sent from my iPhone using Tapatalk