Pixels node for null pixels

[Broadway Lights]

I have pixel strips for my arches they are 3 pixels per section 30 in a stip but my arches are about 25 feet from controller can i use nodes as null pixes to get to the stipes then tie into the stip
Thanks Robin

Sent from my SM-G920P using Tapatalk

[JonB256]

Depending on the controller, try using CAT5 wire to carry the signal. Odds are good that it will work at 25 feet.

From a Falcon F16v2 (which, admittedly already is pretty good at distance) I controlled a string at the end of a 110ft CAT5.  (power was way down, but the data got there perfectly)

[Broadway Lights]

Using sandevicrs  but question is using nodes with a strip both w2811

Sent from my SM-G920P using Tapatalk

[gerry]

Hi , yes u can  use  the nodes as long as the protocol is the same  (the nodes and the ones for the arches) e.g. are both WS2811 .

[Broadway Lights]

Thanks

Sent from my SM-G920P using Tapatalk