« previous next »
Pages: [1]   Go Down

Author Topic: cant get them lit  (Read 1091 times)

Offline scottyv

  • Newbie
  • *
  • Posts: 30
    • View Profile
cant get them lit
« on: December 05, 2015, 09:18:41 AM »
Ok why does every strand of pixels that connect to a output on the alphapix controller leave the first five pixels off? I can turn them on with the testing function of the controller. but I can not get them to light in a sequence. attached is my model the first universe the first strip of lights and the setup page.

thank you or your time
scott
Logged

Offline scottyv

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: cant get them lit
« Reply #1 on: December 05, 2015, 09:58:07 AM »
So I uplugged the LOR dongle to the computer so LOR was not getting any input, and now ten pixels of every strip of lights, that is the strip with wire running to the output of the controller is not lit.
Logged

Offline jediknight2

  • Jr. Member
  • **
  • Posts: 78
    • View Profile
Re: cant get them lit
« Reply #2 on: December 05, 2015, 10:46:10 AM »
I have some time to teamview in and look....

Sent from my LG-H811 using Tapatalk

Logged

Offline scottyv

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: cant get them lit
« Reply #3 on: December 05, 2015, 10:59:10 AM »
I just downloaded teamviewer
Logged

Offline jediknight2

  • Jr. Member
  • **
  • Posts: 78
    • View Profile
Re: cant get them lit
« Reply #4 on: December 05, 2015, 11:06:06 AM »
Pm me the password

Sent from my LG-H811 using Tapatalk

Logged
Pages: [1]   Go Up
« previous next »