Xlights setup for GECE controlled by Falcon F16v2

[cnbales]

I have two F16V2 controllers and one expansion board.  The majority of my pixels are GECE's however, I do have around 1000 2811's.

For the GECE's the Falcon F16v2 interface sets the pixel count at 65 for each port.  Would it be easier to setup xlights as 1 universe per port for the GECE's? Should i check the "One Output" box if I do this?

It seems that it would make it cleaner to do this.

[rfallatt]

FYI,
There is a new "Current Firmware" F16v2_v1.05.fal on the falcon site. this will allow you to set any GECE number per output (I think max 64)
I just upgraded my firmware monday and it works well.