Sean and Team

[Ron Boyd]

Guys,

When running a spiral for slanted bars on a matrix, the bottom row of pixels are off a bit. I noticed it last year on a friends Matrix, and sure enough, it happens on mine too. Inside the program and on the real element.

I've attached a paused screen cap with the bars vertical, to show the glitch a little more clearly. Just thought I'd share

[attachment deleted by admin]

[JonB256]

If you would post a screen shot (smaller) of your Matrix parameters from the model page, I can try duplicating.

I haven't seen that happen on my 40x30 matrix.

edit - OK, on my 40x30 matrix, I can find settings were the bottom gets skewed.

But, when I do the same thing on my 80x60 matrix (the one I never actually built), it is perfect.
I think you are seeing a mathematical calculation problem due to the particular pixel numbers you are using.

Try a really high density matrix model and use the same settings.

[Ron Boyd]

Download the jpeg. It's of the entire NC page. When opened in the forum, it cuts off half of the pic.

Matrix is 16 H x 25 W

Thanks,
Ron

[JerryPlak]

this may Help

[attachment deleted by admin]