« previous next »
Pages: [1]   Go Down

Author Topic: Center effect  (Read 995 times)

Offline djohnson1810

  • Jr. Member
  • **
  • Posts: 58
    • View Profile
Center effect
« on: September 19, 2016, 01:05:35 PM »
So I am working with one of my new mini trees.  I dropped the effect Marque on it.  It looks great in the model preview but when I  output to the actual tree it is offset to the left.  I dropped other effects on it with the same result.  Any ideas what I am doing wrong? It appears that xLights has a different opinion of where the center is than I do.  :-)
Logged

Offline Phrog30

  • Hero Member
  • *****
  • Posts: 1234
    • View Profile
Re: Center effect
« Reply #1 on: September 19, 2016, 01:12:10 PM »
It sounds like you didn't wire up the actual tree like you have the xlights model. I would use tools, test and command specific lights so you can see what is going on.

James

Sent from my SM-G900V using Tapatalk
Logged

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: Center effect
« Reply #2 on: September 19, 2016, 01:13:17 PM »
So what is your opinion of where the center is?
Logged

Offline djohnson1810

  • Jr. Member
  • **
  • Posts: 58
    • View Profile
Re: Center effect
« Reply #3 on: September 19, 2016, 01:19:22 PM »
I left out an important piece. It is a 270° tree. The center is very obvious.  It is a custom tree I made. The 270° may not be exact. Not sure that would cause this problem though.
Logged

Offline djohnson1810

  • Jr. Member
  • **
  • Posts: 58
    • View Profile
Re: Center effect
« Reply #4 on: September 19, 2016, 01:34:03 PM »
https://vimeo.com/183366942


Sent from my iPhone using Tapatalk
Logged

Offline djohnson1810

  • Jr. Member
  • **
  • Posts: 58
    • View Profile
Re: Center effect
« Reply #5 on: September 19, 2016, 02:03:17 PM »
Looks like I should have listened to Phrog30.  Found a wiring mixup.  I am attempting to correct now.
Logged
Pages: [1]   Go Up
« previous next »