Author Topic: Wrong color  (Read 779 times)

Offline adamb123

  • Newbie
  • *
  • Posts: 4
    • View Profile
Wrong color
« on: October 20, 2016, 06:11:27 PM »
I have a problem addressing color as in ok I have pixels which are rgb order and I have Holliday coro alpha pix controller out put 1 is rgb now out put 2 is wrong color is this an xlights setting or my controller I test controller and every output runs the colors properly....as now I have 1 older box I updated firmware and I can't change rgb addressing differently for each output...helllllp

Offline Phrog30

  • Hero Member
  • *****
  • Posts: 1234
    • View Profile
Re: Wrong color
« Reply #1 on: October 20, 2016, 06:45:55 PM »
If output 1 is ok and output 2 isn't, then it's a channel assignment problem.  I'd first start with your network setup, if you have 512 channels per universe then that is your problem.  The alphapix can't handle that.  So, set to 510, or what is actually required.  Use tools/test to test your lights, it will show you exactly where the problem(s) are.

James