Fresh eyes needed

[djmc2002]

Can some one look at this arch model and see if the can see the problem. When I send a sequence to it from xLights, the first 3 arches light, half of the 4rd lights and the 5 and 6 are dark. When I plug in a different strip of lights I get the same results so Im quite sure it is a modeling or numbering problem. When I just send test data from my controller all arches light.

The arches are built with RGB Strips, 50 ic per strip, with 3 RGB per ic, Just standard RGB Strips.
Thanks in advance

[Phrog30]

Isn't your arches 50 nodes per arch. I usually troubleshoot by dropping an on effect at the node level, then seeing which node actually lights up. Might pin point the problem for you.

Sent from my Pixel using Tapatalk

[jnealand]

And your lights per node should be 3.  But I think that is primarily to show correctly in the layout screen.

[djmc2002]

Thanks for the advice. I'll post my results.


Sent from my iPhone using Tapatalk