how to setup San devices # and # 3 cotroller

[Nelson Cabrera]

I have 3 E682 san devices one for my mega tree and the other for my outline, windows door ect. the firs controller for the mega tree in working fine, but I try to enter to san Devices page and is impossible, in x-lights I set  with different IP. The maga tree is 192.168.1.12 the second controller I set on X-lights 192.168.1.13 and the last 192.168.1.14 but I am lost help. help help please

[danj]

You might want to post over at DIYC forum also--there are probably more E682 users over there.    Here are some questions for you--did you go into the E682s' GUIs and change the IP addresses so they match up with xlights as you stated in your post?  Basic stuff-can you ping your E682s?   What IP addresses do you see when you push the (PROG I think) button and watch the LED flashes?   It may be worth going thru the steps in the E682 manual to reset your IP addresses on your E682s.   Can't think of anything else off the top of my head.

[jlowe]

If you are specifying ip addresses in xlights, you need to make sure all of your controllers are set to unicast and not multicast. And that the universes on the e682 matches the universes in xlights.

If you post your configuration of xlights and E682s, that will also be helpful.

And yes, most people here are using Falcon, so the other site might get more help.